The production process of copper stamping parts is roughly divided into the following steps:Raw material preparation.According to the customer's requirements, select the appropriate copper material and cut it into the appropriate size for stamping processing.

Stamping parts are thin plate hardware, that is, parts that can be processed by stamping, bending, stretching, etc. A general definition is - parts whose thickness does not change during processing. The corresponding ones are castings, forgings, machined parts, etc. For example, the iron shell on the outside of a car is a sheet metal part, and some cabinets made of stainless steel are also sheet metal parts.

What process is used to make chassis cabinets？​Chassis cabinets are sheet metal formed products manufactured through sheet metal + welding technology. They have certain characteristics such as safety, beauty, and anti-corrosion.

The motor casing is manufactured through deep drawing and stamping technology. It is often used as a casing product for the motor inside the water pump. It has certain protective features and is widely used in motors used in gardens and field irrigation to improve work efficiency and ensure normal operation. The product is safe to use.

The dimensional accuracy of stamping parts refers to the difference between the actual size and the design size of the stamping parts. The smaller the difference, the higher the accuracy. Ideally, the size of the blanking part is the same as the size of the die edge, and the size of the punched part is the same as the size of the punch edge.

Laser processing of small holes uses a high-energy-density laser as a heat source to cause the material to be processed to generate a local instantaneous high temperature at the point to be processed, turning it into a molten or vaporized state to remove the material.

In cold stamping processing, the process equipment for processing materials into parts or semi-finished products is called cold stamping mold---commonly known as cold stamping die. Cold stamping molds are indispensable process equipment in cold stamping processing. Without selected advanced mold technology, advanced stamping processes cannot be completed

Stretching is a commonly used process in stainless steel processing, but it is easy to produce tensile marks during the stretching process. The formation of tensile scars depends to a large extent on the material and hardness of the stainless steel material, as well as the speed and number of stretches. Once tensile marks occur during the stretching process, it will have a great impact on the quality and aesthetics of the final product

Drawing of mold drawings for metal stamping parts.In a hardware stamping parts processing factory, stamping molds are required for stamping and processing hardware stamping parts. Today I will briefly introduce the drawing of the mold drawing of this stamping mold.

Flanging is a kind of metal stamping parts forming process. Flanging can be divided into elongation type flanging and compression type flanging according to the deformation properties.